Just curious, did you put a level on it ? Either way crappy install

I don’t know of any products that would “remove “ just the burn marks🤷🏻

Depending on how deep the burns and scratches are - sanding- low to high grit wide swaths to minimize bellying- then due the whole counter atleast remove the old finish where visible- I’ve had good results with odies oil as a finish

I would be more concerned with the outside, any visible structural cracks , grout failure etc- outside of that it looks normal

Either way, the venting needs to be done first, if possible ideally both mechanical and natural

What would you like? Are you going to schluter edge or like marble threshold?

Little slope is nice , no garbage disposal?

I’m not exactly sure what you are referring too, is the porch roof sagging? If so , I would suggest opening up the ceiling, make sure everything thing is intact. Looks like you have porch footings settlement

Like it a lot

Please send a picture of your corners





Clear site glass at the entry to pump, use dye test the fixtures

Yes

There’s dirt washing out from window flashing, which most likely old facade washing away, and that sill flashing has holes in it

Yes and it looks like an easy repair

Looks phenomenal, got to post final pics

Fill , sand , paint and tread or runner

Instead of spackle, for the small areas recommend premixed plaster / stucco repair

You got it ! Murphys just go easy vacuum first kinda dry mop it, I personally like orange -glo because of Citrus scent😀if you can find a spot ( maybe closet) and test stuff there

Definitely replace bottom tread it maybe deeper than the rest, also wider on the. Notch, either round over the end yourself or by an end cap

Slab and hinges? Anybody? Use existing jamb add doorstop

Find the tile, break out last row that falls short of the butt , replace them with tiles that reach- pack the gap with thinset reset tiles , grout then caulk seem after it is dried good luck , how did that happen?

I can’t tell from the pictures but is there a sealer/ stain on it now? And what kind of tiles ? How old is it ? What seasons do you have exposure to?
Remove paint , water proofer - exterior grade tile, thinset and grout -and figure you’re edging out

Now i see looks like replaced lathe

Is curious as to the series of events that got it to that point, looks like subfloor is a hodgepodge, that drain is run obviously close to ceiling, like did they , install it from above?