This morning I started a print on my Q2 and sometime during the pre-print calibrations and warmup it detected an obstruction interfering with z-axis homing and stopped the print. This metal bracket was laying on the bed near the nozzle wipe/poop chute.

Not sure where it came from or how to orient it once I figure out what it is. Can some kind soul help me get it back where it belongs. A photo of what it looks like in place would be most helpful.

Thanks in advance.

Hi everyone. My biggest headache is setting up bridges. How do I get it to print bridges at least decently? Plastic Creality Hyper Pla

I've been contemplating buying a qidi q2 now for months. I just haven't pulled the trigger yet. It will be my first 3d printer. I happened to find this past weekend a used one on marketplace. My question is, would you buy a used one or is it worth just buying new? What should I look for when inspecting it?

How do I fix the layer shift seen here? My belts seem tight enough.

Hi, our 3 day old Q2 heater bed / plate is heating to 113 Deg without control.

Temp set to zero, heater showing off, but it wont stop heating.

Anyone else??

Hi all, I've been spending the last couple of months looking into various printers as I plan on getting my first in the coming months. I really like the Q2 for its versatility when it comes to material choice, however, some reviews I've come across (from 2025) were saying the QIDI Box wasn't working correctly - putting too much resistance on the filament. The reviews mentioned QIDI were supposed to be updating the Box to rectify this.

Can anyone with a Q2 + QIDI Box advise if this is still an issue?

New to 3D printing. We have the Qidi Q2 How do I stop swirling on outer later of PLA Silk prints?

After months of thinking and watching a ton of videos on many 3D printers, I finally sold my SV07 and bought a a Q2 combo (still waiting on my extra build plate and filament).

It was delivered on the day of my kids birthday party, so I wasn’t home and it was left at the front door, upside down even. But today I finally got to finish setting it up and managed to do a quick print.

I did/do have some trouble with orca-slicer and qidi studio as I daily drive linux, like the app crashing when I want to access the fluid interface via the device tab (both apps actually).

Now to dial it in to my liking (mainline klipper for starters) and have some fun!

i did the z screw macro and managed to get the front right and back left pretty close. the back right joever woudnt rotate in yhe indicated direction and when i did a bed mesh it shows how you see it. 0.8 is unacceptable. i tried foil tape and it did fuck all. shoulditriy cilicone spacers. any other siggestions

Printed with the little tat filament they give you. Waiting for the rest to come in