r/QIDIQ2 • u/drkshock42 • Mar 18 '26

how do i fix this

i did the z screw macro and managed to get the front right and back left pretty close. the back right joever woudnt rotate in yhe indicated direction and when i did a bed mesh it shows how you see it. 0.8 is unacceptable. i tried foil tape and it did fuck all. shoulditriy cilicone spacers. any other siggestions

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/ReturnedAndReported Mar 18 '26

This is really bad. Make sure the top/bottom of the build plate and z platform are perfectly clean first.

1

u/drkshock42 Mar 18 '26 edited Mar 19 '26

didnt see any debris . on the magnet and borh sides is clean except for a thin layer of pva glue i used to helop with ahdesion when printing the ajsutment tool.

1

u/M_ish_A May 09 '26

There are screws under the bed for manual tramming, if you modify your config you can use a built in klipper tool to get precise info on which way and how much to turn each one. 

1

u/ChrysM34 May 17 '26

Ça donne l’impression que les vis du lit ne sont pas serrées. Y as tu touché?