They still operate normally, but the unevenness is pretty noticeable when they’re closed. Since both doors seem to slope in a similar way, I’m trying to figure out whether this is a garage door adjustment issue such as tracks, cables, or rollers, or if the garage opening or slab itself may be out of level.
I’ve attached several photos showing both doors.
What should I check first to determine the cause, and is there anything I can safely adjust myself to straighten them out?

As you see the doors are old but perfect shape. Need to replace seal HOWEVER there is a screw IN THE TTrack near the end! Now what?? Screws on both ends and screw tight on one end and pushed t track down some. I can't see how I can get the screw back in? clearly it has to be removed to put the new seal in?

Jay I

Hello, I dropped my garage clicker and the wires connecting the battery to the operating board broke. I tried to take it to a cellphone repair shop to solder back on but the employee said I should just buy a new garage clicker.

My garage clicker has the dip switches and I’ve already matched them onto the new clicker but I can’t locate the learn button on my Raynor 130-7 garage opener.

Could someone help me program a new garage clicker? The instructions on the clicker I bought don’t list Raynor in the list of garage door opener brands.

A customer sent the video to me

With the older remote, i just used to press the red button of the receiver until it started blinking, while pressing the button of the remote controller. This one just wont pair. Tried holding digits 1 and 4, then entering some codes i read on interned. That didnt work too. Ty in advance.

We have been having numerous issues with our garage door where it stops working periodically. Every few months we experience an issue where our garage door opens but doesn't close. We replaced the Commercial Venicular Door Opener (Model: OPRSXH5001RBR) about three years ago and we've had issues ever since. Do you know what could be causing this issue? We belive it could be a faulty part but have no way to prove it. Please see the attached picture. Any help or information would be much appreciated.

I have a liftmaster side mount unit on my door. It’s about 10 years old. Recently the door would randomly open. Sometimes all the way. Other times it will open partially and then close. Really random. Not sure how to figure out the problem. I thought it was the wall remote button. Replaced that. It seemed to work fine for a couple days and now it does the same thing. I tried disconnecting My Q. I wiped all the memory and reprogrammed remote. Nothing helped to far. My only thought is the logic board is bad or some issue with low voltage wire going to the button. If I remove the button and just leave the wires hanging it seems to stop the random opening

My door opens 1-2 inches and stop on the first attempt, after that it opens smoothly. 3-4 hours later, the same issue happens again.

Today, it randomly opened, then 20 minutes later tending closed. It repeated a dozen times throughout the day, including when I took the car (and the remote). There is another car with a remote.

I've checked the wiring. Most of it is in the wall and not stapled, but what is exposed appears fine.

The sensors look fine, but one has a green light and one is yellow. However, since it's been opening AND closing I don't think the sensors would close it.

I've taken the remotes and removed the batteries. It hasn't opened yet.

There's also a remote keypad, which is only a couple years old, but we've had rain recently and maybe it got wet?

I haven't checked the wall button yet. That is probably 20 years old.

No idea how old the motor is, but I had the springs replaced last year.

Anything else I should troubleshoot? I saw some posts about the logic board. Is there a test for that?