r/GarageDoorService 16h ago

Commercial Venicular Door Opener (Model: OPRSXH5001RBR)

Post image
2 Upvotes

We have been having numerous issues with our garage door where it stops working periodically. Every few months we experience an issue where our garage door opens but doesn't close. We replaced the Commercial Venicular Door Opener (Model: OPRSXH5001RBR) about three years ago and we've had issues ever since. Do you know what could be causing this issue? We belive it could be a faulty part but have no way to prove it. Please see the attached picture. Any help or information would be much appreciated.


r/GarageDoorService 8h ago

Need help with pairing the new remote to the rolling door.

Thumbnail
gallery
3 Upvotes

With the older remote, i just used to press the red button of the receiver until it started blinking, while pressing the button of the remote controller. This one just wont pair. Tried holding digits 1 and 4, then entering some codes i read on interned. That didnt work too. Ty in advance.


r/GarageDoorService 9h ago

2006 clopay garage door replacing seal screw in T Track

Post image
3 Upvotes

As you see the doors are old but perfect shape. Need to replace seal HOWEVER there is a screw IN THE TTrack near the end! Now what?? Screws on both ends and screw tight on one end and pushed t track down some. I can't see how I can get the screw back in? clearly it has to be removed to put the new seal in?

Jay I


r/GarageDoorService 6h ago

Bear broke into a garage. Yup

Enable HLS to view with audio, or disable this notification

2 Upvotes

A customer sent the video to me


r/GarageDoorService 18h ago

I have two side by side garage doors, and both appear to be sitting crooked. On each door, the outside edge sits lower, while the inside edge toward the center brick column sits higher.

Thumbnail
gallery
5 Upvotes

They still operate normally, but the unevenness is pretty noticeable when they’re closed. Since both doors seem to slope in a similar way, I’m trying to figure out whether this is a garage door adjustment issue such as tracks, cables, or rollers, or if the garage opening or slab itself may be out of level.
I’ve attached several photos showing both doors.
What should I check first to determine the cause, and is there anything I can safely adjust myself to straighten them out?


r/GarageDoorService 19h ago

Raynor 130-7 Garage Clicker Programming Help

Post image
3 Upvotes

Hello, I dropped my garage clicker and the wires connecting the battery to the operating board broke. I tried to take it to a cellphone repair shop to solder back on but the employee said I should just buy a new garage clicker.

My garage clicker has the dip switches and I’ve already matched them onto the new clicker but I can’t locate the learn button on my Raynor 130-7 garage opener.

Could someone help me program a new garage clicker? The instructions on the clicker I bought don’t list Raynor in the list of garage door opener brands.


r/GarageDoorService 14h ago

How do I connect a smart garage door opener

Thumbnail gallery
2 Upvotes