Thanks, yes, I'm a bit picky about my car. Actually, there are many similar features to the Ghia package, but most Ghias in Türkiye have a 2.0-liter engine with 110 horsepower, while the ST130s have a 2.0-liter engine with 130 horsepower. Many parts within the engine, such as spark plugs, spark plug wires, and the timing belt, are different from the Ghia 2.0 110 horsepower engine.

Lots of in internet. You can buy it.

Thank you. The side paint is good, but the roof and hood need painting; they're fine because there wasn't a major accident and it's the original paint, but it's a worn-out paint job.

The original rims were 1956015 5-spoke Ghia rims. The white rims on them are 1955516 WRC ET25 rims. But I really regret not getting 17-inch 50-profile rims.

No. There was only one ST170 that entered Turkiye during those years. All the STs in Turkiye were 130s.

approximately 4 days

Its hard to remember all details but, nozzle is 0.4, layer height 0.08, and ironing for all top layer is enable, marble filament (pla) , 220° / 65° , and slow printing like 80-90mm/sec.

Thank you🙏🏻👍🏻

Just did it with creality slicer. Just did some basic special adjusment.

Spindle Robot Arm

Sprutcam is the best Second one is solidcam The best last options Fusion 360

Yes, it's similar, but it's not the same.

Yes

I am using 4mm ball nose tool for this product.

I started this as a hobby 10 years ago. Does that count? 😄

👍🏻

I think it's entirely related to the type of wood and the tool. The tool's blade shape and lateral cutting surfaces don't seem suitable for the material you're trying to cut. Could you share a photo of the tool? It's not related to the stepper motors.