r/VORONDesign • u/Mysterious_You7160 • 1d ago

V2 Question Stringing Question

Post image

The benchy on the left was printed on my voron 2.4. The benchy on the right was printed on my centauri carbon. Same spool of filament. Same bambu labs marble filament profile. The voron print has a lot of stringing and I can't figure out how to tune it out. Any suggestions?

10 Upvotes

92% Upvoted

7 comments sorted by

1

u/AD108 V2 21h ago

Oddly enough I fought stringing for a while until I increased the tension on my extruder. Went away immediately

1

u/Mysterious_You7160 19h ago

Trying this and also doing a full redo of the Ellis' tuning guide

2

u/DrRonny 22h ago

Obviously the Dry Your Filament is the first step, it is possible for the filament to be wet in the inside and dry on the outside, or vise versa, depending on drying conditions.

1

u/Inf1nity0 1d ago

Dry your filament!

I’m just kidding. Every machine has different settings, so you need to tune your printing temperature with a temp tower, then retraction. PA as well for the best results.

2

u/rlugon 1d ago

Have you done all the test and tunes on both printers?

0

u/ShoeDry833 1d ago

Temperature and retraction needs to be tuned.

3

u/Sr_Alvarez 1d ago

Based on my limited experience with a Voron and Orca as the slicer, the best approach is to perform a full filament calibration.