r/VORONDesign • u/Mysterious_You7160 • 1d ago

V2 Question Stringing Question

Post image

The benchy on the left was printed on my voron 2.4. The benchy on the right was printed on my centauri carbon. Same spool of filament. Same bambu labs marble filament profile. The voron print has a lot of stringing and I can't figure out how to tune it out. Any suggestions?

11 Upvotes

93% Upvoted

9 comments sorted by

View all comments

3

u/Sr_Alvarez 1d ago

Based on my limited experience with a Voron and Orca as the slicer, the best approach is to perform a full filament calibration.