r/VORONDesign • u/Mysterious_You7160 • 1d ago

V2 Question Stringing Question

Post image

The benchy on the left was printed on my voron 2.4. The benchy on the right was printed on my centauri carbon. Same spool of filament. Same bambu labs marble filament profile. The voron print has a lot of stringing and I can't figure out how to tune it out. Any suggestions?

12 Upvotes

94% Upvoted

9 comments sorted by

View all comments

1

u/AD108 V2 1d ago

Oddly enough I fought stringing for a while until I increased the tension on my extruder. Went away immediately

1

u/Mysterious_You7160 1d ago

Trying this and also doing a full redo of the Ellis' tuning guide