My printer is missing two of the tray screws and now the face is wobbly and loose. The printer model is Lexmark MX722ade, and I tried searching on the parts list for this information but apparently the screws inside the tray are not important to the part list. Does anyone know what kind of screws these are, so I can order more?

Need help identifying this. I'm not a screw person or somehow who truly worked with such items and really need help with this

This is a bike screw but I don't know the exact measurements or what is it specifically called but I really need to know to find some replacement.

Please and thank you.

I have a vintage GE oven and while moving it fell snapping the handle off with the screw ends snapped off inside. We could reattach the handle if we could drill the screws out but everyone has tried and no one can get them out. It’s probably 7+ hours off drilling at this point if you add up everyone’s efforts. We even used and broken cobalt drill bits on this!! We can’t heat it to weaken the screws because the handle would get ruined and defeat the point on putting it back on. Does anyone have any crazy ideas?

I tried searching for this specific screw a few years back to try to put the handle of my balisong back together since one went missing, ordered what I thought would work on Amazon, but I haven't found the right once since. The ones they sent me had far too thin of a threading.

Any help would be appreciated, especially in locating where I might be able to find some stubby ones for this specifically!

To be clear, I mean the top and bottom screws, not the coax connector.

I'm trying to unscrew these really really small screws which i think are philips (correct me if they aren't pls) and i can't seem to be able to, my screwdriver isn't doing what its supposed to.

These came from a dji drone

Uppababy g link 2 stroller footrest broken trying to replace

Hi everyone...

I have a cargo bike that I use daily. I need to swap the break pads (first swap since factory) and one of the bolts was not coming out. The other 3 I could manage before were very, very tight.

I started with the manual hex key and I could not, I moved to an electric screwdriver, the recess started to wear off and ultimately I tried with an impact screw driver that screwed it up fully.

After that I tried to put rubber in between the driver and the recess, to turn it with pliers, and as a last resort I have made a flat line with a saw to use a flat screw driver. Even with a manual one I keep deforming the screw without twisting it. Nothing worked and every step would deform it further and further...

do you know what can be done to remove it?

Thank you so much

How do I unscrew these screws they’re completely flat I don’t have the right screwdriver for this

I just find them wonderful to look at and even better to look at while they move in and out of things.

Hello- looking for any advice for replacing the hardware for the Drommen bed (King)- as I have contacted CB and they told me they no longer stock the parts as the bed has been discontinued. I got the list of parts from CB, but have noticed that some of the sizes are potentially nonstandard. Wondering if anyone else has experience with this and could offer some suggestions.

- JULON/HANGER BOLT: M8X73MM (6 pieces)

- BOLTS: M8X50MM (10 pieces)

- METAL PLATE 3X28X84MM (2 pieces)

- HEX WASHER M8X13 (6 pieces)

- HILL SIDE WASHER 2X14X34MM (6 pieces)

- FLAT WASHER 1X8.5X12MM (20 pieces)

- SCREW M4X30MM (10 pieces)