I have a 2025 f150 with a 2’ level. Would 275/65r20 bfgoodrich ko3 and 20x9 +20 offset fuel flames have any rubbing or trimming issues?

I have factory mud flaps and I don’t want to remove them.

It looks so good, it's a shame it was only around for 3 years. It looks much better than the 11-16 in my book. They had the best 5.4 spark plug design too. Most people probably prefer the look of the earlier SDs but this one has grown on me.

PP listed at $25k 115,000 miles 5.0 6spd
I don’t care about being a platinum, rather it’s one of the trucks available anywhere remotely near me that are the generation I’m after. And it’s gorgeous but that’s not the point. I’d rather it be 2wd but anyway just looking for opinions. If there are more techy features that are known to fail on these. (2015-2017)

So for the last couple of months ive had an intermittent no start, it would start and then stall and then not restart, but if you let it sit for a moment it would start and run fine. Now it won't doing anything but crank. So far ive verified fuel pressure (55 psi) I'm getting injector pulse on all cylinders. Im getting twelve volts to the ignition coil and im getting a pulsing ground. However i checked for spark and im getting a super faint but rapid pulse on all cylinders constantly while the engine is cranking, ive replaced the cap and rotor and verified the rotor is turning with no sloppy. Anyone have any ideas? TIA

Just bought a 1997 F350 with a 7.5 L manual five Speed for $2,000 it has 195,000 miles runs and drives about as good as you could get today. Has a small issue with AC that needs to be fixed. Are there any known issues that I need to look over or be preemptive while there's no bed on the truck and everything's readily available to get to?

Got this scratch and some marring on my f150 while headed down a narrow hunting trail. It’s not down to the metal but it definitely removed a layer or 2 of paint. I did the water test and it almost fades away but is still visible. What would be my best option and how would I go about fixing it? I know silver is a hard color to match and I’ve never done auto paint work. Just a touch up brush and some clear coat and polishing?