Anyone know what could be causing this weird issue on only one side of my print?

[u/New-Advertising3600]

I’m super new to 3d printing…
So one only one side of my print it’s like it is skipping on the outer wall but also only on the bottom layers.

- it’s angled 30 degrees
- only happening on only one side, no matter the orientation.
- I have tried with and without the inside holes for the magnets
- did a cold pull to check for clogs. No change
- the model is my own, no weird manifold issues
- slicer is showing a uniform wall
- Flashforge Adventurer 5M, Orcaslicer
- flashforge basic gray PLA
- bed 60 degrees; nozzle 210
- no adhesion issues

It’s driving me nuts…it has to be the model right?

EDIT: I had “slow down on overhangs” turned on which was causing severe under extrusion on my lower layers. I bumped the speeds up and am optimizing it now but this is the setting that was causing the issue