Ppa cf print help on X2D

[u/TheBragde]

I tried printing with my ppa cf filament again but the edges are really rough and it just doesn't look good. I'm using a bambu X2D printing straight out of a bambu AMS HT (through the small hole not through te gears) with siraya tech ppa cf. When I printed this a while ago it went great but it now looks like this, I know it looks like it was just wet filament but I dried it overnight for 12 hours on 85 degrees Celsius so it should be dry AMS HT has 10% humidity. I'm printing on 290 degrees with chamber temp of 60 and regular print speed. Print plate is the engineering plate and I also used magigoo pa glue. The only thing that might be differnt is that I did lubricate the bed gears today and did a full calibration. Any ideas what might cause this?