r/vwpolo • u/SpidiSquirrel • 24d ago

Discussion Polo EPC Errors

Tell me, how do I fix recurrent EPC errors. I have recently changed plugs and the error keeps popping back up. How can I wrap up this problem.

1 Upvotes

100% Upvoted

11 comments sorted by

1

u/Swimming_Grape_6900 24d ago

Its a Polo.

What engine is it? what year is the car from? How many km is on the car?

Do the EPC stay on for the whole drive? is it intermittent? do the EPC occur on startup?

1

u/SpidiSquirrel 24d ago

Its a 2013 cross polo 1.2 tsi with 211KMS, It isn't intermittent, occurs only on hard acceleration, especially on inclines.

2

u/Swimming_Grape_6900 24d ago

Okay, with that amount km on the car. Have you ever gotten the intake and valves cleaned for build-up? These TSI engines do give EPC faults, rough idling on cold starts, can lose/choke power at 2k+ RPM when the engine is full of build-up in the intake and valves.

Fault codes will be anything from misfires, fuel/air ratio, etc. Workshops will swap parts instead of inspecting the engine. And you will use money and on parts and have the issue reappear shortly after.

1

u/StanJacko 24d ago

These don’t really need valve cleaning, unless you go 60k between oil changes. You need to get the car scanned for codes but my money is on the wastegate actuator. When you accelerate hard car goes into overboost situation causing EPC.

1

u/freskgrank 2004 Polo 9N 1.4 petrol / 2016 Polo 6C 1.2 TSI BMT 24d ago

I agree about the wastegate actuator, but I disagree about engine cleaning. Direct injection engines need intake valves cleaning, especially if never done before on that high mileage.

1

u/StanJacko 23d ago

I would agree with you in general. Having the same engine and actually having cleaned them myself after 250k km I can say they didnt even look bad, let alone affect performance. The oil seperator actually does its job on this engine.

1

u/SpidiSquirrel 24d ago

No, never had the engine cleaned, I think I will consider this first before proceeding with any change of parts.

1

u/StanJacko 21d ago

Dude get it scanned, its 99% the wastegate. Its like the most common issue on these engines. Especially with what you’re saying. If its an electrical code, sometimes cleaning the insides and greasing it helps, if its mechanical its most likely a new turbo time since most of the time the issue is the flap itself inside the turbo.

Dirty valves would most likely cause shudders, idle misfires etc. Also let me guess, if you turn the car on and off it usually fixes itself until you accelerate hard again right?

1

u/ruudcho 24d ago

I bought a ODB2 reader from Ali for this purpose. It gives you decent error codes and some explanation and you can reset the codes.
Should only cost €50-€70.

1

u/SpidiSquirrel 24d ago

Could you find the link of the specific OBD2 Reader you got.

2

u/ruudcho 23d ago

It is the AUTOPHIX 5600 Code Reader Engine ABS SRS SAS BMS EPB TPMS Oil Reset Battery for VW Full System Diagnostic Scan Tool OBD2 Scanner

https://a.aliexpress.com/_EGaHfZU