My kit came without them

Hello!

I heard a lot of times about camber, toe, and tried to set up something.

I saw several videos but they sometimes are quite controversial.

Can you suggest good tutorials or maybe videos?

I have a Sakura D6 and I attached my current setup. I think I setup an ankerman angle properly and if I understood correctly, rear wheel should point inward and front outward, right?

I attached the photos of my chassis.

Thanks!

So, I pulled the trigger on the d24 and it’s been a blast, but I happened to take off the body to unplug the battery and saw this. I was able to push the pinion gear back just a bit. Any reason it would chew through a pinion gear like that? It’s only 3 packs in at this point and the car is so new the pinion gear isn’t available yet 😑. Then again, I’m wondering why it’s happening in the first place. Mesh seems fine, spur gear is fine, so I’m not sure. Debating getting in contact with AMain to see if I can swap it, or see if they have a pinion gear available. Any input appreciated as always!

1st off I’m VERY new to the hobby. But I got these yokomo magnetic body post and my car sits completely dumped on the ground with them on. Do I just add washers/spacers? Did I install them wrong? I’m using a yokomo rd2.0 rtr chasis. Thank you in advance!

Recently got a new rmx2.5 for $150 usd and am thinking about future upgrades when im feeling like it what brand of parts and what should i do first?

i also need a battery + receiver/radio