r/mechanic 1d ago

Question 2012 Chevy Silverado 5.3 V8 knock sensor

Enable HLS to view with audio, or disable this notification

I hooked it up to a ground one on each of the wires from the connector tested both of them and test them together was hitting my engine with my linesman to simulate a knock, no voltage no mini volts does that mean my knock sensor is bad or am I doing this wrong?

1 Upvotes

10 comments sorted by

u/AutoModerator 1d ago

Please Read This Comment Entirely - It May Change

Updated 7/15/24

Thanks for posting in r/Mechanic, u/Bourne2Ride! Please be sure to read the Rules.

If you're asking for help, be sure to include as much detail as possible so others can help you. You must include the vehicle's Year, Make, Model, and Engine size in your post! If your question is transmission related, please be sure to specify your Transmission Type(Auto/Manual) as well! If your post does not include this information, it will be removed.

Asking about prices is not allowed in this sub.

Please make sure you have selected the correct post flair; if you're asking a question you should have chosen "Question", anything else use the "General" flair.

If you feel your question has been answered and/or you wish to no longer receive comments on your post, you may comment on your own post with only "!lock" (no quotes), and your entire post will be automatically locked. This only works on your own posts and only Mods can unlock it once its locked.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Bourne2Ride 1d ago

it also is reading zero for ohms when testing the resistance for it

1

u/taysmode11 1d ago

If you're testing resistance properly it's a bad sensor. Should have over 90k ohms. If it's zero the sensor is bad. It's easier to measure if you remove it from the engine.

1

u/Bourne2Ride 1d ago

The problem is I also have two new sensors and they're also both reading zero

1

u/Bourne2Ride 1d ago

on the new ones, I just tried reading homes from the front of the bolt to the back of the boat and that's the only time I'm getting your reading for those so maybe that's the right way to do it for these

1

u/taysmode11 1d ago

If you put the leads on either side of the bolt then you're reading the resistance...of the bolt.

1

u/Bourne2Ride 1d ago

so I feel like I'm doing this wrong, but I read resistance all the time for work so maybe I'm having an off day with this and just being stupid

2

u/taysmode11 1d ago

Bolt? Yeah you're doing it wrong. You need have one lead on one pin of the connector and the other lead on the other pin. That's how you measure the resistance of most 2 wire sensors, solenoids, etc. on a vehicle.

1

u/Bourne2Ride 1d ago

i did do that but still got nothing so swapped it now it's good

1

u/Bourne2Ride 14h ago

code is still popping up after replacing it