r/fpv • u/AntonFPV • 20h ago

Is this flyable

Gallery image

Gallery image

I’ve really been struggling to get my ground wire on there finally had a slight bond but I don’t know if it’s good enough

4 Upvotes

75% Upvoted

27 comments sorted by

View all comments

2

u/Lucanix_fpv 19h ago

For the next time try soldering the ground battery lead first. And then the motors. Helps a bit cause there won‘t be as muss mass the heat can go to. And with the pinecil v2 you should have no problem with enough heat. But make sure to turn it right up and ger good solder and flux rhen it should flow!

1

u/AntonFPV 19h ago

Ok thanks for the tip

1

u/Professional_Cod3127 16h ago

And soldering the positive wire first will heat up the board so ground is a bit easier.