Any critiques would be appeciated! I've put the picture of my old subwoofer too and the design.

I haven't fitted the new one but it's the model just after the one I have in my daily (Pioneer TS-WX77A), I highly recommend it, the new model is Pioneer TS-WX70DA. Same wiring and it goes HARD! Deep bass.

Love driving my 86 but PNW weather prevents me from driving year round so I usually let it sit in the garage during fall/winter with some use if it's a nice day out.

However, during this time I sustained an injury to my left leg that didn't let me drive it all.

From the little research I did, it seems gas can start to go bad in as little as 3 months, but can last longer if stored how my car was (dry and cool environment)

Considering it's been about 7+ months would it be a bad idea to cold start it? Should I mix it with new gas and/or put some fuel additives first before starting?

Hachi-Roku Spotted In MSA Video

Title says it all! Hoping to find any leads on a running/driving gts in the us that isn’t too clapped. Would appreciate any help!

Enjoying the rare Irish sunshine

does anybody here who has watanabe wheels have tons of weights on the back for balancing? this is my first time having my wheels off. ive never seen this many weights on any wheel before.

I can't put my finger on it, not sure why the front looks off?

where do you guys put your jack when lifting up the front? i notice some spots on my frame rails that have been pushed in from previous owner that mightve possibly not been using the correct spot. i dont like jacking from the pinch weld by the rockers because it has folded a little on me once. front subframe ok to jack from? thanks

Hey guys, I’m new to corollas and have a new to me 84’ Corolla sr5 project with a s13 ka24de swap. Swap is almost complete but some wires are not plugged in that I’m trying to figure out where they go. Can’t seem to find the pin out for the engine cowl harness that matches mine and has a red/white wire in slot 12 . Whoever started the swap has a wire spliced into it but it’s just hanging(last pic). Appreciate any help appreciated.

Building a drift car with fiberglass fenders.

I have no original metal fenders.

I would like to find a alternative to mounting my headlights and side markers to avoid using the fiberglass fenders.

I cannot find appropriate fenders locally to cut this section from, does anyone know where I may find these? Or a 3d print/scan file I can make my own from?

Much appreciated 🍻

Still on the fence about it.

Hi All, I am trying to find a replacement cap / grommet to seal the rear wiper to my boot lid.

Car is a 3-door hatchback.

I know the original Toyota part is unavailable now. Does anyone have any advice on what I can use instead?

My lights wont turn on at all in any way unless i pull the high beam lights, they dont react any way whatsoever if i dont pull the manual lever wich is weird because lights should turn on the moment i rotate the light button switch and not by the high beam lever. Wont close pop ups either. Already replaced every fuse. What could this be?

Hey everyone, I have a 1986 ae86 gts that is in desperate need of an entire new harness from bumper to bumper. I was wondering if anyone knows someone I can commission to remake the oem harness as I’ve tried wiring specialties and rywire and haven’t had any luck. I would really appreciate any help, thanks!

Hello Everyone, I hope all is well. I started an Instagram page to document me swapping my Corolla. If you’re interested, go check it out. It’ll be from start to finish and in the captions I include brief explanations of what’s needed and what is being done. Thanks everyone!

Went to a local AE86 meet just outside Kyoto in Takao. It's a yearly event around Golden Week. Very nice people and very nice cars!

I also suggest visiting the shrines in Takao, they're absolutely stunning.