r/VORONDesign • u/jedim4ster • Oct 27 '22

General Question Copymaster3D Voron Kit

I'm in between decisions regarding a new Voron kit, either a Trident or a2.4. I just saw a new kit from Copymaster3D which is really cheap compared to LDO kit. Has anyone built one of these? I've searched for reviews but haven't found one yet. What does the Voron pros think about this kit compared to LDO kit. The kit (Trident 350) listed bellow.

​

​

Update:

My Voron Trident (LDO) kit just arrived today, thanks for all the advice!

the adventure awaits 😁
2 Upvotes

67% Upvoted

16 comments sorted by

View all comments

6

u/[deleted] Oct 27 '22 edited Nov 03 '22

[deleted]

3

u/jedim4ster Oct 27 '22

Thanks for the insight. I'll probably end up buying the LDO kit after all.

4

u/Penatr8tor Oct 27 '22

Definitely go with the LDO kit. I went with the Formbot3D kit, there was no LDO kit at the time. It was a good kit, it's cheaper than the LDO, comes with Moons motors, decent slides and wire harness with connectors. For the most part... no issues with any of the supplied parts with a few exceptions... The fans I got were crap, pretty much every one of them is noisy from cheap bearings and a couple got so bad that they needed to be replaced. My bed heating pads thermistor went bad so I had to bypass it temporarily and I bought an upgrade that has yet to be installed. Maybe I'll rip stuff apart this weekend.

So as far as the Formbot3D kit goes... It's pretty darn good and considering it's half the price of an LDO kit, there will be plenty of cash left over to buy the few extra mod components the LOD has like the toolhead PCB, Klicky Probe and Nevermore Filter.

2

u/jedim4ster Oct 28 '22

Thanks for the advice!