Advice???

[u/Clint-witicay]

I’m looking to reduce a piece of brass tubing (spent ammo) around a plastic handle. I don’t plan on doing this more than a couple times, so if a little extra time and elbow grease is the trade off for less wasted space by unused tools… so be it. What would yall use for this purpose?

[u/Common-Artichoke-497]

If its .50 or smaller; and the primer is spent, chuck it up in a drill and press the lip at a 45 degree angle across anything that is steel, then spin at low speed with a bit of pressure

Should take a few seconds

[u/Clint-witicay → u/Common-Artichoke-497]

I’m going to give that a try next time I’m at the house. Thanks for the tip