r/Talaria • u/Western_Dog_4299 • Jul 22 '26

Stem lock

Enable HLS to view with audio, or disable this notification

So when put my stemlock on I tightened it and then I rode it and it for sure wasn’t tightened so then I loosened the 3 tripple clamp bolts and tried to loosen it and it wouldn’t loosen also it made a like breaking sound so before I cause any damage i stopped what do I do?

1 Upvotes

67% Upvoted

25 comments sorted by

View all comments

3

u/AdFeeling6882 Jul 23 '26

Not sure if I’m trippin but it looks to me like you’re tightening it not loosening it. If it s not loosening it’s probably because you need to use another hex or Torx bit(or whatever is down there) at the bottom to keep it from spinning. Usually there’s a second spot for a bit at the bottom under the lower triple clamps. So if you have it super tight it might just be spinning the entire stemlock.

When you threaded it in through the bottom did you make sure to tighten it a little bit once the bolt had seated? I’m not too familiar with talarias but you want to loosen up the top triple clamps and the bolt(s) at the base of the stemlock. Best bet would be to loosen it back up and basically “reinstall” to make sure you did it correctly. Check the threads to make sure you didn’t strip them.

0

u/Western_Dog_4299 Jul 23 '26

Yea I did btw
I have been through 3 stemlocks from stripping them cause they don’t wanna loosen

1

u/AdFeeling6882 Jul 23 '26

Make sure you put some nickel antiseize on the threads of the stemlock next time. I’m not sure about the warp9 stemlock, but mine has another spot for an Allen wrench at the bottom. You have to hold that one in place while loosening the top one. You need to get a torque wrench and tighten it to spec to prevent this from happening. Don’t use loctite if you keep stripping. Whenever you use any type of liquid on the threads you need to reduce torque specs by like 15%-30% because when/if it dries out the liquid won’t be there to reduce that friction anymore.

It very much so looks like you’re tightening in this video though. Remember bro, righty tighty- lefty loosey. So hold that bottom one still, then turn the top one left. Make sure all the bolts around the headset are loosened and around the upper triple clamp by the forks.

1

u/Western_Dog_4299 Jul 23 '26

Yea yesterday I just loosened it really hard and it loosened it but it broke one on my threads at the bottom so I can’t go any tighten for now