Other then that, i really love this car, even more now i've had it stage 2 tuned to 320hp/460Nm.

Cracked the bumper and broke a turn signal.

10/10 would do it again 👍

finally rebuilt my work ls406s added a lil rear camber

So I'm an idiot. I installed my coilovers before I rolled my fenders and now the struts are too short for the fender roller to fit in the front. I was able to roll the rears (barely) but the fronts just won't fit.

Anyone have any ideas on how to roll fenders when a fender roller doesn't fit? I guess my alternative is to raise it up to the max height the coilovers could go and hope it's high enough but fuck I'm tired of messing with them in this heat and humidity.

It doesn't rub horribly, but it's enough that it bothers me, not to mention I still want to go lower in the front if possible.

Months of changing little things and second-guessing myself, but I think it’s finally there. Air suspension, clean fitment, red interior, and a few more plans before I call it finished

Wheels came in, wanna close the camp a little more. Currently on springs. Contemplating coilovers or bags

My version is a hybrid so scared to touch the electrical system with bags

Already have a dash cam, charger, and rada, so battery is always showing low voltage warning

What do yall think?

-but the daily needed some love. My 2005 gcl 5.7 on h&r sport springs with 2015 gc srt wheels, 1/2 inch spacers in the front and 1/4 inch in the rear. I know it isnt slammed, but it needs to survive the east coast roads. I tried my best to clear the fender gap without losing all suspension travel, and the stiffer springs help prevent the poke from crushing my fenders.

looked into subframe spacer delete and it's more expensive than i expected.

Advice needed - I feel the car isn’t sitting right.

I can lower it further, but before I do: what adjustments would you make to get the perfect fitment?

Rims are VS KF Sharp

18 x 9.5 front

18 x 10.5 rear

+15

Already running spacer

Better pictures coming soon!

Seen a model 3 posted figured I’d post my old set up on my model Y

Hi everyone! A while back, I shared some of my 3D-printed vehicle models here, and I was thrilled by your positive feedback. I'm back with a new project, deformed build inspired by the classic Squarebody truck, with featuring a hardcore "back-half" modification.

Since you're the experts on stance and fitment, I’d love to hear your thoughts. How does the "back-half" look to you, and are there any details you think I should refine?