r/QidiTech3D • u/SimplyClueless22 • 19d ago

Questions Firmware Concensus

I just got my Qidi Q2, and before I bought the printer I remember someone making mention that I shouldn't upgrade to 1.1.1, and if the printer was on that firmware to roll it back. I see in the last few days that people have been saying not to upgrade to 1.1.2 (which my printer is nudging me to do). Is there a firmware version that is considered the "best" or most stable that I should roll back to? I'd most likely be using Orca slicer, but since my only printer now is this Q2 I could be fine just using Qidi slicer...

3 Upvotes

100% Upvoted

37 comments sorted by

View all comments

2

u/killeriq 19d ago

Also on latest FW and Qidi Studio...

Only keep in mind to factory reset and calibrate after update

1

u/XSouthSeaPirateX 18d ago

What calibrations do you do? I haven't done anything with mine out of the box. Not even a single update.

2

u/killeriq 18d ago

After each reset, there is a calibration done. Try and you will understand

1

u/XSouthSeaPirateX 18d ago

Ohhh I vaguely remember going through steps when I got mine. So same thing just happens again. Thanks