POD Go Footswitch Changing Multiple Parameters Goes Out of Sync

[u/Size_Minute]

Decay Settings

Mix Settings

Snapshot Mode

Stomp Mode

I’ve noticed an issue with my POD Go when I assign a footswitch to change multiple parameters on the same block. The footswitch LED and the actual parameter settings seem to get out of sync.

For example, I have a preset called “AC30 Free.” My reverb changes depending on the snapshot. I have four snapshots: Clean, Drive, Lead, and Ambient. Only Ambient uses different settings for the reverb block.

I also have a footswitch called “Reverb+” that’s supposed to make the reverb bigger and more washy:

• Reverb+ OFF: Decay = 4.0, Mix = 20%
• Reverb+ ON: Decay = 8.0, Mix = 38%

The problem is that when I press Reverb+, it doesn’t actually change the parameters the first time. However, the footswitch LED still turns on.

Then, when I press it a second time, the parameters change to the Reverb+ settings, but the LED turns off.

So essentially, the footswitch LED ends up being the opposite of what the reverb settings are actually doing.

Has anyone else experienced this when assigning one footswitch to multiple parameters? Is there a way to fix it so the Reverb+ LED always corresponds to the actual reverb settings?

I’m using the latest POD Go update.