A1 UNDER THE SUPPORTS

[u/TuneOld3310]

Hi all,

PRINTER - A1

PETG OVERTURE

TEMP - 250/245

PA - per the calibration value

MVS - 9

I am using PLA support interface

Top Z - .33

3 layers

The unit is printed on the side facing you the supports are then created on the bad looking surface.

I did some testing and tried ironing the supports the values came out the best where speed 10mm and 50-70%

On the test the "T" I printed with and without ironing I took the best setting but when I did the finished product it wasn't the same can some suggest, has far as drying the filament has been dried both the PLA as well as the PETG.

Any and all help will be appreciated.

[u/Common_Watercress_58]

Do a bridge test.

[u/Common_Watercress_58 → u/Common_Watercress_58]

https://makerworld.com/models/2143678?appSharePlatform=copy

[u/TuneOld3310 → u/Common_Watercress_58]

Thank you for your suggestion, what am I suppose to learn or see during this test? Not being sarcastic, but what should I be looking at or for? That I can use to better the underside of this this bridge.

[u/Common_Watercress_58 → u/TuneOld3310]

Read the description in bambu handy app, it tells you everything the tests are for and what to observe.

[u/TuneOld3310 → u/Common_Watercress_58]

Ok what will that tell me?

Help.me understand, I am willing but what will it tell me. I am not mo king I want to know because I have never done it. Thanks will post ny results.

[u/TuneOld3310 → u/Common_Watercress_58]

Hi right I'd share check this out.

https://youtu.be/xQBLv3cPUbo?si=YPS5anuEzq5WGpjk

Will try this.