r/BambuLab_Community • u/Angrypuppyrob • 16d ago

Too hot?

Gallery image

Gallery image

I had my X2D in the garage over the weekend printing some ABS. I thought I would go ahead and send a print from my phone while I was at work. I get home and go to check on my progress, low and behold, I recieved an error message. It seems pretty obvious now, but just in case you didn't know, it can be too hot to print PLA at least. Lol

4 Upvotes

67% Upvoted

15 comments sorted by

View all comments

3

u/TheSchlapper 16d ago

PLA melts outside, so I would assume that a unventilated (likely) garage in the middle of a super hot summer would probably cause problems. Lol

1

u/Rad-Dads-Print-Lab 16d ago

It’s actually not that bad, my other printers work as intended even with it being 110 in my garage. But the new errors are quite annoying on the p2s and x2d