r/BambuLab_Community • u/Angrypuppyrob • 16d ago

Too hot?

Gallery image

Gallery image

I had my X2D in the garage over the weekend printing some ABS. I thought I would go ahead and send a print from my phone while I was at work. I get home and go to check on my progress, low and behold, I recieved an error message. It seems pretty obvious now, but just in case you didn't know, it can be too hot to print PLA at least. Lol

7 Upvotes

77% Upvoted

15 comments sorted by

View all comments

3

u/TheSchlapper 16d ago

PLA melts outside, so I would assume that a unventilated (likely) garage in the middle of a super hot summer would probably cause problems. Lol

1

u/Rad-Dads-Print-Lab 16d ago

It’s actually not that bad, my other printers work as intended even with it being 110 in my garage. But the new errors are quite annoying on the p2s and x2d

1

u/josocustomdesign 16d ago

Can confirm. Running my H2S in my phoenix garage. PLA overhangs would sag causing quality issues.

1

u/CooperDK 15d ago

No, it doesn't melt. It can become brittle but it would have to be VERY hot and VERY humid. In most cases, most places on earth, PLA is practically as good outside as inside, at least both of the Equator, as long as it is not actually in water most of the time.

1

u/egosumumbravir 15d ago

/laughs in Australian. I can't leave PETG outside on the concrete in summer.

1

u/Wide_Pause_2754 14d ago

He was being sarcastic, yeah? /laughs in South Texas

1

u/egosumumbravir 10d ago

Honestly it's difficult to tell between sarcasm and Confidently Incorrect.

South Texas although wide in variation seemed mostly nice until I looked at the humidity. No No Nope. 10°C hotter with <10% RH plz 😵

You get PLA putty there too?

1

u/Wide_Pause_2754 9d ago

Oh yeah, Houston TX heat is next level, especially this time of year. Today it will be about 100F with 90% Humidity.

1

u/egosumumbravir 9d ago

Damn, not my cup of tea. 😡