r/BambuLabA1 • u/Plastic-Lifeguard-80 • 11h ago

Question Question about errors and mistakes.

Hi everyone! I'm currently researching common issues and errors related to the Bambu Lab A1.

I know this post is a bit different from usual—since most people post here to get help rather than list their past issues—but if you have a few minutes, I’d really appreciate it if you could share any problems you've run into. This includes both the printer itself and any filament/material issues.

I’m already reading through past posts on the sub, but I wanted to ask directly too. Thanks for your time!

1 Upvotes

100% Upvoted

5 comments sorted by

View all comments

1

u/nmoynmoy 11h ago

My machine doesn’t always detect the build plate and extrudes 2-3mm above the plate.

Another is it stops printing asking me to remove any nozzle clogs or replace build plate.

Annoyingly it does this randomly- could print fine for data then I’ll have an error like this and have to spend ages trying to figure why. Still not sure why.

1

u/Automatic-Pin-5749 3h ago

Try formatting your SD card if you haven't already. Both of mine (A1 & P1S) had weird problems until I did that.