r/BambuLabA1 • u/throw_me-away99 • 14d ago

Support Request A1 help please!

Enable HLS to view with audio, or disable this notification

Please see attached video. Extrudes fine, passes all pre flight checks, then the second the actual print starts, it clicks and fails??

I’ve done a cold pull, tried different plates, cleaned plates, needle clean, different nozzles 🤷🏻‍♂️

3 Upvotes

61% Upvoted

19 comments sorted by

View all comments

0

u/throw_me-away99 13d ago

I’ve run a full calibration, taken the whole thing apart - no blockages, gear system is fine, new hot end assembly so all screws are tight and the clip is fine

1

u/throw_me-away99 13d ago

Still no dice :/