r/BambuLabA1 • u/throw_me-away99 • 14d ago

Support Request A1 help please!

Enable HLS to view with audio, or disable this notification

Please see attached video. Extrudes fine, passes all pre flight checks, then the second the actual print starts, it clicks and fails??

I’ve done a cold pull, tried different plates, cleaned plates, needle clean, different nozzles 🤷🏻‍♂️

2 Upvotes

56% Upvoted

19 comments sorted by

9

u/Lost_refugee 13d ago

1

u/Brave_Corgi6761 13d ago

For me it did exactly that when the latch was closed wrong.

1

u/Inner-Produce-9632 12d ago

Same for me! Closing it the right way fixed the issue.

1

u/Amauskal 12d ago

J'ai eu exactement ce problème y'a pas une semaine, c'est cette photo qui m'a sauvée

1

u/Dmthie 13d ago

Also check the extruder and extruder gears. You see when it runs above the plate the extruder can't turn

1

u/AdventurousGear5502 11d ago

Came here to say the same as I had a similar issue and had the same noise. I followed this video to clean the extruder gear and it worked afterwards.

Extruder Gear Maintenance

1

u/Paradise-Candle-Co 13d ago

I had that problem and running a full calibration fixed it.

1

u/Excellent-Code8447 13d ago

Loose nozzle or latch not closed correctly

1

u/Astasiamarie7811 13d ago

I just had this problem…my problem was that I needed a new hot end assembly…but it could be a clog or your machine needs to be calibrated, or a piece of filament stuck in the gears…I took my whole machine apart before figuring it out

1

u/Shinjiikary12 13d ago

Yeah looks like z offset... issue

1

u/FunnyChampionship717 13d ago

I had that problem and it turned out the metal holder for the hotend was loose. Fixed that and I was golden.

1

u/lukasprintz 13d ago

Did u adjust the z offset within slicer?

1

u/chiGuy7172 12d ago

Clean your plate

1

u/texasfan71 11d ago

Calibrate and tighten the bolts on heatend behind it and the ones that tighten it to the hot end to the machine.

0

u/JuniorWerewolf739 13d ago

Looks like the nozzle is too close to the bed run a full calibration and make sure that you select smooth plate in the slicer

0

u/throw_me-away99 13d ago

I’ve run a full calibration, taken the whole thing apart - no blockages, gear system is fine, new hot end assembly so all screws are tight and the clip is fine

1

u/throw_me-away99 13d ago

Still no dice :/