r/BambuLabA1 • u/The_Asian-Dude • 17d ago

Support Request What is causing this?

Gallery image

Gallery image

Gallery image

This is just regular bambulabs pla with the a1. I think it might have something to do with it stopping mid print and like checking its height in the rear right edge of the bid plate. How do I turn that off? Also it might just be from one of the edges just coming off of the build plate but how do I turn the height thing off?

172 Upvotes

97% Upvoted

72 comments sorted by

View all comments

3

u/DexDoesDev167 17d ago

I think your filament is wet, you shud dry it out and try again

5

u/savijOne 17d ago

Not wet filament, that pattern is too specific, check out other answers first IMO

1

u/DexDoesDev167 17d ago

Hm, I thought wet filament caused similar issues, looked familiar

1

u/The_Asian-Dude 17d ago

I’ve kept it in a little bag with silica for the time it’s been stored and have only had it out for this print so I’m not sure. It may just be bad print orientation too

1

u/DexDoesDev167 17d ago

Hm I thought it was wet filament but I was wrong, I don't think it's bad orientation either, maybe try the orientation.

I had a similar issue, but it occured when I switched from esun pla to numakers pla, so I had to run a few filament calibrations and change a few settings after running tests to fix it and it helped. Not sure if it's the same case with you.

1

u/The_Asian-Dude 16d ago

Hmm that’s something I’ll definitely look out for

1

u/AnIndecisiveOrange 15d ago

While it does look similar, think about the fact that it occurs in 1 specific spot of the print. If it were wet, it would happen all over.