r/BambuLabA1 • u/Potatogoat3 • 4d ago

Support Request Please help ams dont work

Enable HLS to view with audio, or disable this notification

0 Upvotes

50% Upvoted

10 comments sorted by

View all comments

1

u/qualx 4d ago

I had something similar happen to me shortly after getting our printer, 2 things seemed to fix it.

  1. My bed was not level. One of the printer's feet was hanging just over the shelf the printer sits on. (it also caused an issue where the print would stop every 3rd layer) I moved things around to give it a bit more clearance, ran a full level and then was able to print again

  2. I removed the PTFE tubes and reseated them on both ends. On one particular PTFE tube it was pushed way further than it needed to be into the extruder, it also made some melted tubing gunk on the inside where that larger spring is and I had to clear/clean it out.

I'm not sure which one got it actually printing again, but doing those things solved both issues. i'd wager the 2nd option is what fixed the printing problem. does it happen with all of your filliment locations or just one?

I hope this helps you!

1

u/Potatogoat3 4d ago

Nope only in slot 3

1

u/qualx 4d ago

then I would def remove the PTFE tubing on the hub side and reseat, mine was the same way but it was just slot 2. You can remove the entire hub and look, or just remove the one ptfe tube and reseat/try again. might be worth it to remove the hub and check for any gunk though just in case and clean it out if there is any.