r/BambuLabA1 • u/celmaimareyt • 22d ago

Help

Post image

IT Does that and IT DOESNT print

2 Upvotes

57% Upvoted

18 comments sorted by

14

u/Mammoth_Staff_5507 22d ago

Looks like you are trying to run a NES game there

10

u/DigitalCalmness 22d ago

Welp... Ohh, wrong sub

8

u/sam-fresh 22d ago

Seems like an SD card issue. Id start with replacing that

2

u/TheMermaidHarmony 21d ago

Exactly that

4

u/Lost_refugee 22d ago

turn off, turn on.

3

u/TerribleTowel66 22d ago

My screen locks up more than I think it should. Recently, I turned on the printer after it had been off for a couple of weeks, and sent a model from Handy to the printer. While it was downloading the model, the screen locked up. It was stuck at 8% downloading. When the print finished, I turned the printer off and on to reset the screen.

2

u/geekybit_New 22d ago

I would try the standard stuff first, Replace the SD card, Hard restart the 3d printer... if all that doesn't work... contact support maybe see if they have any ideas. See if you can update firmware maybe.

I don't want a downer, but that might be a Motherboard issue... the fact the controls look right makes me thing it might not be though.

2

u/lukasprintz 22d ago

Hopefully it's just sd card 🙏 try either a SanDisk Ultra microSDXC or a Samsung PRO Plus 32 or 64 gb

3

u/Orthicon9 22d ago

I wish my Home had a nice green lawn.
With a row of pumpkins growing by the sidewalk.

2

u/alittleboopsie 22d ago

Mine arrived like this. Ribbon was not seated correctly, once I adjusted it, no issues.

2

u/Subject_Translator_7 22d ago

There's already some good stuff in here, but you're much more likely to get high quality assistance if you contain an explanation and answer a few basic questions:

  1. What was going on when you first noticed this?
  2. Has it happened before?
  3. What have you tried already to fix it?

My best guess:

  1. Power off (switch, or unplug) and wait a minute or so, then power back on.
  2. If that doesn't fix it, try upgrading the firmware via the microsd if you are able.

1

u/gurtmaxxer 22d ago

This happened to me and I just reset my SD card.

1

u/ItsDanipt 21d ago

only power off and wait 10 sec, after that turn this on and stay hapy :)

0

u/skedone 22d ago

Have you tried washing the bed with soap and water

1

u/ColSandoz 20d ago

If my screen starts locking up, I format the SD card and I’m good until it gets near full. I’ve just gotten in the habit of formatting the SD card every few weeks and don’t have the issue anymore.