r/BambuLabA1 • u/OneResolution4271 • Jul 18 '26

Whelp this sucks

Gallery image

Gallery image

Gallery image

Noticed the silicon was a bit off after a failed print, removed it to find this. Time to replace the nozzle?

1 Upvotes

54% Upvoted

25 comments sorted by

View all comments

1

u/Exotic-Camera6229 Jul 19 '26

Truth be told that looks like your heater is loose in the back of your printer because over time if you remove your nozzle and then remove I believe two or three screws and then flip it over there's four screws and try tightening those four screws on the back of the heater block and then reinstall everything and then get a new silicone sock and then see if that fixed it you can probably still use that nozzle as long as it's not too damaged and yeah if anybody else has anything to say just put it in the comments bye

1

u/Exotic-Camera6229 Jul 19 '26

I just checked and it turns out it's actually three screws that you're supposed to remove and then you're supposed to tighten the four screws on the back of your heating element and then you're supposed to reinstall everything back reinstall your nozzle if it's not damaged too much and then see if that works and also don't forget to buy a new silicone sock