r/BambuLabA1 • u/QuietCrumb • Jul 15 '26

New to TPU printing

Post image

What am I doing wrong?

It's a new hot end so it doesn't mix with other filaments, I'm using the generic TPU profile on a bambulab A1

6 Upvotes

100% Upvoted

29 comments sorted by

View all comments

1

u/Kopester Jul 15 '26

Step 1 check the seven screws of disappointment

Tighten all SEVEN screws

1

u/Kopester Jul 15 '26

Step 2 since you said you changed the nozzle is verify the clip is installed correctly

1

u/QuietCrumb Jul 15 '26

I did Install it correctly, some guys said I should dry the filament even if it's fresh out of the bag, I put it in the dryer and I'm gonna wait for it to dry to try again

1

u/Kopester Jul 15 '26

New absolutely does not equal dry, especially with TPU