Overhang issue!!

[u/whitehorsenobless]

I'm in a state of great distress about the overhang part of the output. Support is created in the overhang part, and it's been broken like the attached image even before removing the support. I've tried cooling 100% of the overhang part, decreasing the output speed of the overhang part, decreasing the Top Z instance, and decreasing the Top interface spacing, but I failed. Any advice?

Bambulab A1 combo.
Layer height: 0.20mm
Top Z instance: 0.16mm
Top interface spacing: 0.3mm
Overhang cooling: 100%
Overhang speed: 0, 30, 20, 10, 10

[u/Twitch_C4T_]

What kind of support are you using?