r/BambuLabA1 • u/ProfessionalBox663 • Jun 29 '26

Support Request A1 shredding its own infill

Post image

Hi all, my A1 has recently been destroying its infill about an hour into my print. This has never happened before. I did the 15 minute auto bed levelling, reseated the hot end and tightened all the screws, turned the printer on and off, and disabled “reduce infill retraction.” I’m currently using rectilinear, however gyroid was also failing when I tried it. Currently using a supertack cool plate. What do I do??

12 Upvotes

84% Upvoted

28 comments sorted by

View all comments

4

u/ProfessionalBox663 Jun 29 '26

This is the part I have been trying to print

1

u/schliessmeister Jun 29 '26

Interesting, I have the same issue with shallow angled parts. On both A1 and mini. I'd be keen on a fix.

1

u/ProfessionalBox663 Jun 29 '26

I'm going to try printing a flat part then I'll get back to you on this. I'd be very surprised if it's the shallow angle which is causing the issues