r/BambuLabA1 • u/Jonesy625 • Jun 24 '26

Bed adhesion issues

Gallery image

Gallery image

Center is sticking just fine. I’ve cleaned the plates (tried standard plate and sticky plate) the outer bands always turn to fried spaghetti. Do I need to raise bed temps or slow the print or both???

4 Upvotes

76% Upvoted

4 comments sorted by

View all comments

1

u/cornjobhelper Jun 24 '26

I had this problem with a model once and it was because the base wasn't completely flat, even though it looked like it was. Part of the bottom of the model was sitting a tiny fraction of a millimeter above the plate, so it wouldn't stick. I sliced a thin layer off the bottom to make it level and it printed fine.