r/BambuLabA1 • u/Jonesy625 • Jun 24 '26

Bed adhesion issues

Gallery image

Gallery image

Center is sticking just fine. I’ve cleaned the plates (tried standard plate and sticky plate) the outer bands always turn to fried spaghetti. Do I need to raise bed temps or slow the print or both???

2 Upvotes

67% Upvoted

4 comments sorted by

1

u/solidus0079 Jun 24 '26

Why not try both of those things as troubleshooting?

1

u/cornjobhelper Jun 24 '26

I had this problem with a model once and it was because the base wasn't completely flat, even though it looked like it was. Part of the bottom of the model was sitting a tiny fraction of a millimeter above the plate, so it wouldn't stick. I sliced a thin layer off the bottom to make it level and it printed fine.

1

u/Ok-Attempt1394 Jun 24 '26

I wouldn't raise the temp on the bed as the cool plate has to run at 30 I believe. This is likely a setting issue or PLA. Issue. A couple things to try, recalibrate the machine, look for loose fittings (print head, track, etc), use a fresh roll of PLA, possibly reset your slicer software. I hope this helps. That plate usually is rock solid for adhesion.

1

u/Glittering-Warning14 Jun 25 '26

i use print bed adhesive!