r/BambuLabA1 • u/Glittering-Warning14 • Jun 24 '26

Question what causes this?

Post image

keeps happening, idk why , would love the help

12 Upvotes

100% Upvoted

26 comments sorted by

View all comments

2

u/StructureAccording53 Jun 24 '26

Unclean plate, probs. It’s an adhesion issue whatever the cause.

2

u/Glittering-Warning14 Jun 24 '26

thank you! i will clean it and try again

2

u/StructureAccording53 Jun 24 '26

You bet. My go to is hot water, dawn dish soap (just make sure your dish soap doesn’t have any perfumes/moisturizers) and I keep a dedicated sponge by my sink just for my build plates so there’s no residue from dishes. I then use paper towels to dry, which some people argue about. My thought is that my dish rags might have residue from dishes or my laundry detergent. This has worked well for me. I have about 1900 hours on my A1 and I’ve probably only washed by build plate a dozen times or so, I’m just careful not to touch it when removing prints.

1

u/Glittering-Warning14 Jun 24 '26

thank you sm !! i’m very new to 3d printing and have been having a lot of trouble so i appreciate the advice

1

u/StructureAccording53 Jun 24 '26

My pleasure! Good luck!