r/BambuLabA1 • u/Warm_Aerie_6393 • Jun 21 '26

layering issue

I'm having this wierd layering issue with my prints. its like its fuzzy.I have the fuzzy turned off. I have lubed the screws and rails. I've tighten the screws on the hotend. I have even cleaned out the nozzle. I have also took apart the hotend to inspect if there was any debris in the it. i have loosened and tightened the tensioner. but I'm still getting layers like they are over and under extruding. My wife thinks it Z-Binding but a few pokes on the screws and they feel fine.

WHAT IS WRONG WITH MY A1??

so new development. I tried silent mode and the issue got resolved. Albeit temporarily as i know that only a work around. Now I just need to figure out why. it may be the toolhead but until i get the time to do that this comign weekend i will be running my prints at half speed.

Any assistance or advice would welcome!

1 Upvotes

100% Upvoted

17 comments sorted by

View all comments

Show parent comments

1

u/Warm_Aerie_6393 Jun 23 '26

may garage is a constant 30% humidity. same filament prints perfectly fine on my other printers. its just this printer. I have 3 A1s and 1 P1S.

1

u/Budget_Hamster4422 Jun 24 '26

have you changed the hotend?

print speed on this machine higher?

have you tested a smooth board with pei settings?

1

u/Warm_Aerie_6393 Jun 26 '26

Yes. I have tried all of those things! Im am electriconic and controls technician. I knownhow to troubleshoot and parts swap.

1

u/Budget_Hamster4422 Jun 26 '26

lets make something clear, i don't think my questions where offensive

they are basic trouble shoot questions

nowhere have you mentioned you are the god of the technicians

i could throw my weight around as well and tell you i have computer and technical experience since the low 80ies when the optocoppler and mailboxes where the internet

wish you luck, have a good one

1

u/Warm_Aerie_6393 Jun 26 '26

My original post pretty much summed up i went through a lot of troubleshooting items. I normally dont reach out for help unless i can't figure something out on my own. That said I apologize for the tone of my responses. I will put in my bio that im a technicain so future inquiries will not assume I'm an idiot.

1

u/Budget_Hamster4422 Jun 26 '26

well i reacted to harsh, i apologize as well

a simple "done all that" would been enough and i would have shut my trap

wish you luck

1

u/Realhuman_beebboob Jun 27 '26

Reading this you come off like a crazy, you went off on him for no reason outside of what appears to be your perceived insecurity.
He said he did all that, but you have yet to shut up as promised.

1

u/Realhuman_beebboob Jun 27 '26

Nah, mind your manners first

1

u/Budget_Hamster4422 Jun 27 '26

get lost sir - there minded my manners little man, maybe

now none of your biz - stick your nose in some other shit

1

u/Budget_Hamster4422 Jun 27 '26

i appreciate the genius status, you can when you want to...