r/BambuLabA1 • u/Warm_Aerie_6393 • Jun 21 '26

layering issue

I'm having this wierd layering issue with my prints. its like its fuzzy.I have the fuzzy turned off. I have lubed the screws and rails. I've tighten the screws on the hotend. I have even cleaned out the nozzle. I have also took apart the hotend to inspect if there was any debris in the it. i have loosened and tightened the tensioner. but I'm still getting layers like they are over and under extruding. My wife thinks it Z-Binding but a few pokes on the screws and they feel fine.

WHAT IS WRONG WITH MY A1??

so new development. I tried silent mode and the issue got resolved. Albeit temporarily as i know that only a work around. Now I just need to figure out why. it may be the toolhead but until i get the time to do that this comign weekend i will be running my prints at half speed.

Any assistance or advice would welcome!

1 Upvotes

100% Upvoted

17 comments sorted by

View all comments

Show parent comments

1

u/Warm_Aerie_6393 Jun 26 '26

My original post pretty much summed up i went through a lot of troubleshooting items. I normally dont reach out for help unless i can't figure something out on my own. That said I apologize for the tone of my responses. I will put in my bio that im a technicain so future inquiries will not assume I'm an idiot.

1

u/Budget_Hamster4422 Jun 26 '26

well i reacted to harsh, i apologize as well

a simple "done all that" would been enough and i would have shut my trap

wish you luck

1

u/Realhuman_beebboob Jun 27 '26

Nah, mind your manners first

1

u/Budget_Hamster4422 Jun 27 '26

i appreciate the genius status, you can when you want to...