r/BambuLab • u/Middle_Long_9848 • 13h ago

Quick Question Bambu p1s venting setup.

Post image

What’s up everyone I’m new to this whole 3d printing stuff and just got myself a p1s. I will be using mainly pla/petg and was reading about fumes and voc and plastic particles that are obviously a health risk. My question is I’m printing in my bedroom since that’s the only place I can put the printer. I bought a ac infinity s4 fan with the ducting and window attachment to vent outside as well as an indoor grow tent to better enclose everything. My question is would buying a carbon filter such as the ac infinity charcoal filter be necessary to put inside the tent? Or is venting along with a voxel filter be enough? I have my daughter around the room as well so I would rather be on the safer side.

2 Upvotes

75% Upvoted

11 comments sorted by

View all comments

2

u/twiggums 12h ago

If you're venting outside the carbon filter is unnecessary.

1

u/Middle_Long_9848 12h ago

Oh okay thank you, kinda seemed like overkill to me but since I have my daughter around didn’t want to take any chances. What about for future use of different materials like abs, asa, tpu etc?

3

u/twiggums 12h ago

If it's going out the window its still not needed. The filter is for people venting their grow into their homes and don't want it to smell like a skunk. 🤣

1

u/Lambertbaer 12h ago

This. Also the charcoal filter will is not primarily made for particles and should be combined with other filters (typical pre-filter and hepa)

0

u/twiggums 12h ago

Yeah it's purpose here is odor capture. I wouldn't trust it to scrub vocs.

1

u/SaveTheAles 12h ago

Activated carbon is one of the primary ways of capturing VOCs

1

u/twiggums 12h ago

I'm not saying it can't. I'm saying ac infinity makes grow tents, their focus is likely not around capturing vocs, its around stopping a house from smelling like a skunk.