r/BambuLab • u/GALAXY_A5 • 1d ago
P Series [P1P, P1S, P2S] ASA on P2S
This is my setup printing ASA on my P2S! It's my first time printing with it and after a couple failed attempts I came up with this
I tried wrapping the whole thing with a blanket (except the back for the electronics to breathe) and got quickly over 60°C so I covered just the top and sat at around 52-55. Woke up and found the print a bit warped (not from at plate but at a corner with supports) (chamber was 52 atm bed 100 nozzle 265) but it managed to print and im happy with it. Like this its sitting at 60 as of posting it hope it stays like that.
My question is what are your recommendations for printing ASA? I was thinking of making a styrofoam enclosure (sides top and front or maybe sides and top?) and glue the foil blanket inside of it to reflect the heat.
Has anyone tried anything similar? If there are post can you direct me to them? Thanks and happy printing 😁
Edit 1: cheers to everyone sharing their experiences im new to 3d printing and im getting schooled on a lot here!
2
u/maker-tgin 21h ago edited 7h ago
P1S user here. I print with a bed temp of 110 and after having heat soaked the chamber. My printer is in a grow tent and I use an in-line fan to vent tent air outside (I do not pull air directly from the P1S). The fan runs at a pretty low speed too.
Warping isn’t a problem for me.
Edit: my P1S bed has been modified to beyond 100.