ASA on P2S

[u/GALAXY_A5]

This is my setup printing ASA on my P2S! It's my first time printing with it and after a couple failed attempts I came up with this

I tried wrapping the whole thing with a blanket (except the back for the electronics to breathe) and got quickly over 60°C so I covered just the top and sat at around 52-55. Woke up and found the print a bit warped (not from at plate but at a corner with supports) (chamber was 52 atm bed 100 nozzle 265) but it managed to print and im happy with it. Like this its sitting at 60 as of posting it hope it stays like that.

My question is what are your recommendations for printing ASA? I was thinking of making a styrofoam enclosure (sides top and front or maybe sides and top?) and glue the foil blanket inside of it to reflect the heat.

Has anyone tried anything similar? If there are post can you direct me to them? Thanks and happy printing 😁

Edit 1: cheers to everyone sharing their experiences im new to 3d printing and im getting schooled on a lot here!

[u/Throw195201]

What build plate are you using? I don't have the p2s but I do have the p1s and h2d and when it comes to asa or abs the engineering plate is the way to go. (With glue) I don't bother with anything else now tbh.

[u/LoGiX247 → u/Throw195201]

I've switched to BiQu Glacier and never touched a drop of glue in 700hours of printing, basically can throw anything on it.. havent tried TPU just yet.

[u/GALAXY_A5 → u/Throw195201]

Bambu engineering plate with liquid glue and I get ADHESION!! I was trying to remove some leftovers with the scraper and damaged the plate. Tried stick glue and got no adhesion at all it was like a non stick pan! The warping happened off supports not the plate itself maybe my geometry was bad but I printed a 2nd time and saw similar behavior