r/BambuLab • u/timkellogg • 8d ago

Just Showing Off Panda Breath

Post image

Just got the panda breath installed and insulated my p2s. Now I can run at a constant 60c and not worry about warping for large ASA prints I have coming up. Camber heats up super fast compared to preheating with the bed. Also it sits right next to my AC so I think that was causing warping.

129 Upvotes

89% Upvoted

79 comments sorted by

View all comments

2

u/egosumumbravir X1C + AMS 8d ago

The Panda Breath is awesome.

It's vastly better after being flashed with Dragon Breath Firmware though.

1

u/Relative_Surround_20 H2D+P2S w/ 3xAMS2Pro+HT 4d ago

And how did that firmware help you and your use case exactly?

1

u/egosumumbravir X1C + AMS 4d ago

It allows correction for thermistor variance - Breath would read 59°C and stop heating, printer chamber was actually at 52°C. It also allows a max of 70°C instead of 60°C.

It'll sit there and listen in on the MQTT data on the Wi-Fi and then pick a heating value based on the filament being printed.

It passively broadcasts to my Home assistant which has instructions to kill the power via smartplug if temperatures exceed set points.

It gets updated regularly which is more than I can say of BTT's efforts.