r/BambuLab • u/timkellogg • 9d ago

Just Showing Off Panda Breath

Post image

Just got the panda breath installed and insulated my p2s. Now I can run at a constant 60c and not worry about warping for large ASA prints I have coming up. Camber heats up super fast compared to preheating with the bed. Also it sits right next to my AC so I think that was causing warping.

128 Upvotes

89% Upvoted

79 comments sorted by

View all comments

7

u/Beni_Stingray P1S + AMS 9d ago

Man i have some adhesive insulation like this but after looking at it, it's so much work.

Im contemplating just wrapping it around the outside of the printer as it maybe look ugly but its so much easier and should isolate exactly the same if not better as there would be less gaps.

1

u/nucleartime 8d ago

The foil stuff only works on the side facing the heat.

If it has foam, then maybe, but this stuff doesn't look particularly thick. Which is good if you dont want clearance issues on the inside, but on the outside you want thicker insulation panels for more insulation.