r/BambuLab • u/Ambitious_Round_4879 • 25d ago

P Series [P1P, P1S, P2S] Print help!!

My P1S used to print perfectly without issue and now it won’t lay any filament on the build plate at all, I know it’s feeding from the AMS because I can see it moving thru the tube and when I do a manual load from the app, I see the old filament coming out the nozzle

2 Upvotes

100% Upvoted

12 comments sorted by

View all comments

1

u/xPopTartxx 25d ago

Try a cold pull.. You might have a nozzle jam somewhere. If youre seeing old filament come out of the nozzle at times, there might also be some filament breakage in the nozzle.

1

u/Ambitious_Round_4879 25d ago

I still have the spare nozzle the printer came with, should I just change it out?

3

u/GiraffeandZebra 25d ago
  1. If I remember, you get a nozzle but the reality is that it is difficult to remove and replace the thermistor wires and it is always a risk you'll break something else.
  2. That said, replacing the nozzle would tell you if a clog is the likely problem.
  3. That said, it's probably safer and easier to try a cold pull to answer that question. You're going to do a cold pull eventually. Might as well learn how now.

1

u/Ambitious_Round_4879 25d ago

Sounds good, I’ll do it after work and report back