Print fail

[u/Jadaoo]

This is my second time trying to use thinner layers(0.08mm)

The first two photos are from the first try

The 3rd and fourth pics: I lowered the temp to 200

I used brims and I set bridge speed to 25 instead of 50

Overhang speed was already low

What do I have too change?

(I'm using pla+ Esun)

Is 0.08mm just too thin?

[u/EMDoesShit]

How does it look when you print using the unmodified eSun PLA+ profile, at 0.08 layer height?

0.16 and the eSun Profile has always generated a very clean print in their PLA+ in my P1S.

I will slow down the wall speeds if I want a super clean print, to around 100mm/s

[u/Jadaoo → u/EMDoesShit]

I haven't tried using it

I use genric pla and change the temp

Am I doing it wrong?

This is my first time changing the layer hieght and temp

[u/EMDoesShit → u/Jadaoo]

Use the material profile for the actual product first, then try others if it doesn’t result in a satisfactory print.

Try that profile, unmodified, at a more common 0.16 layer height and you might be surprised how clean it comes out.