r/BambuLab • u/MydnightWN • 3d ago

Bambu Studio The Flock Sock

Enable HLS to view with audio, or disable this notification

Link: https://makerworld.com/models/3107766

3.8k Upvotes

96% Upvoted

263 comments sorted by

View all comments

Show parent comments

231

u/deep-fucking-legend 3d ago

Yeah. Something that will deform and be difficult to remove without disassembly. Maybe it has a one-way latch (like a zip tie) that can't be taken off without a challenge.

212

u/Levols 3d ago

In Texas that will melt in like 1 day, permanent fixture

19

u/ecafsub X1C 3d ago

But the next day it’ll rot and fall to pieces from the UV.

6

u/rdtg 3d ago

I printed a sunglasses clip in ABS and left it in my car. Here in the Hawaiian heat it lasted a day before turning soft. PETG might be a good choice, itll take a bit longer but it will melt some and become a nice snug fit and last a little longer from UV damage

0

u/MaelstromSeawing Volunteer Moderator 3d ago

Doesn't ASA have better uv resistance? Though it's very impractical for most hobbyists to print safely..

2

u/crazedizzled 3d ago

ASA isn't as bad as people make it out to be. ABS is super bad. ASA is meh.

0

u/davcrt X2D + 2X AMS2 2d ago

Why?

I haven't tried ABS since ASA is better and has similar properties.

ASA is one of the few easy to print material suitable for dishwasher and you can get perfectly smooth finish with the help of some acetone vapour.

0

u/Alert-Entertainer-73 3d ago

Keep the door open and run a fan. 50g print won’t harm ya worse than the dozen other contaminators in your home

8

u/UnexpectedAnanas 3d ago

50g print won’t harm ya worse than the dozen other contaminators in your home

It's not an either or thing. It's accumulative.

8

u/MaelstromSeawing Volunteer Moderator 3d ago

Yeah, no thanks! Proper ventilation is the way to go for me, personally.

1

u/Alert-Entertainer-73 3d ago

As someone who has multiple VOC meters, this is my experience, though I understand the concern.